Every outdoor sign in Phoenix is governed by the municipality’s sign ordinance, which sets how large a sign may be, how tall it may stand, how far it must sit from the property line, whether it may be illuminated, and which sign types are permitted in each zoning district. This page summarizes those requirements in plain language and links each value back to the section of the Phoenix code it came from.
Sign rules here are layered. The base zoning district — commercial, industrial, or residential — sets the default limits, and overlay districts such as historic or downtown districts can tighten them further. Because the most specific jurisdiction controls, a freestanding monument sign on a commercial parcel and a wall sign in a historic overlay can face very different limits even on the same street in Phoenix.
Use the figures below as a fast first check, then run a full address lookup to confirm the exact limits for a specific parcel in Phoenix, Illinois. The full report also covers permit requirements, prohibited sign types, and illumination rules — each cited to the source ordinance so your permit application can reference it directly.
Before you order or install a sign in Phoenix, confirm three things: the maximum sign area and height allowed in the parcel’s zoning district, the minimum setback from the right-of-way, and whether the sign type you want — freestanding, monument, wall, projecting, or awning — is permitted there at all. Many permit denials come from missing a setback or an overlay-district restriction rather than from the size of the sign itself, so checking the governing section before applying saves a costly resubmittal.
Advertisement
Advertisement
Freestanding
Freestanding Ground Monument
Source-backed freestanding/ground/monument sign rules: 58. Prohibited acts; notice; removal. (a) Nonconforming signs. In case any sign shall be installed, erected or constructed in violation of any of the terms of this article, the chief building inspector shall notify, by registered mail, the owner or lessee thereof to alter such sign so as to comply with this article, and to secure the necessary permit therefor, or to remove the sign. If such order is not complied with
Illumination
Illumination
Source-backed illumination rules: ct or maintain a commercial illuminated sign shall be for one year. The permit fee shall be in the amount established by the board of trustees. (e) Same—Renewal. The chief building inspector may issue a renewal of the permit issued hereunder upon the expiration thereof, or within 30 days thereafter, upon the payment by the applicant of a renewal fee in the amount established by the board of trustees, accompanied by c
Advertisement
Advertisement
Permits
Permit Required
Source-backed sign permit requirement: ess that is to be operated under such license; (7) A statement as to whether the applicant has made similar application for a similar license on premises other than described in this application, and the disposition of such application; (8) A statement th --- SIGN CODE FOCUSED SLICE --- 6-23 Bond required ............................................... 6-21 Permits required ...........................................
Source-backed wall sign rules: 56. Projecting signs. (a) Location; dimensions. No projecting sign shall be erected on the front, rear or side of a wall of any building so as to project above the roof or cornice wall or above the roof level where there is no cornice wall; except that a sign erected at an angle to the building, the horizontal width of which sign parallel to such building does not exceed 18 inches, may be erected to a height not exce
Wall Signs 2
Source-backed wall sign rules: e wall nor above the roof level where there is no cornice wall. A sign attached to a corner of a building and parallel to the vertical line of such corner, shall be deemed to be a vertical sign and subject to all the restrictions of this section pertaining to projecting signs. (b) Specifications. Every projecting sign must be constructed and braced to withstand a horizontal wind pressure of 30 pounds for every square