Understanding sign regulations in St. Augustine Beach, FL
Every outdoor sign in St. Augustine Beach is governed by the municipality’s sign ordinance, which sets how large a sign may be, how tall it may stand, how far it must sit from the property line, whether it may be illuminated, and which sign types are permitted in each zoning district. This page summarizes those requirements in plain language and links each value back to the section of the St. Augustine Beach code it came from.
Sign rules here are layered. The base zoning district — commercial, industrial, or residential — sets the default limits, and overlay districts such as historic or downtown districts can tighten them further. Because the most specific jurisdiction controls, a freestanding monument sign on a commercial parcel and a wall sign in a historic overlay can face very different limits even on the same street in St. Augustine Beach.
Use the figures below as a fast first check, then run a full address lookup to confirm the exact limits for a specific parcel in St. Augustine Beach, Florida. The full report also covers permit requirements, prohibited sign types, and illumination rules — each cited to the source ordinance so your permit application can reference it directly.
Before you order or install a sign in St. Augustine Beach, confirm three things: the maximum sign area and height allowed in the parcel’s zoning district, the minimum setback from the right-of-way, and whether the sign type you want — freestanding, monument, wall, projecting, or awning — is permitted there at all. Many permit denials come from missing a setback or an overlay-district restriction rather than from the size of the sign itself, so checking the governing section before applying saves a costly resubmittal.
Advertisement
Advertisement
Authority
Sign Chapter Scope
Source-backed sign ordinance/chapter scope: 00. Purpose, intent and scope.\nIt is the purpose of this article to promote the\npublic health, safety and general welfare through\nreasonable, consistent and non-discriminatory\nsign standards. The sign regulations in this\narticle are also designed and intended to meet\nthe statutory requirement that this municipality\nadopt land development regulations that regulate\nsignage,\na\nrequirement\nset\nforth\nin\nF.S.
Sign Chapter Scope 2
Source-backed sign ordinance/chapter scope: ign standards. The sign regulations in this\narticle are also designed and intended to meet\nthe statutory requirement that this municipality\nadopt land development regulations that regulate\nsignage,\na\nrequirement\nset\nforth\nin\nF.S.\n§ 163.3202(f). The sign regulations in this article\nare not intended to censor speech or to regulate\nviewpoints, but instead are intended to regulate\nthe adverse secondary effe
Source-backed freestanding/ground/monument sign rules: measured\nas the entire illuminated surface or\nilluminated element which contains\nsign copy.\nd.\nDouble-faced signs. If a sign has\ntwo display faces, and the interior\nangle between the two faces is thirty\n(30) degrees or less, then the sign\narea is one sign face only; however,\nif the two faces are of different sizes\nor shapes, then the larger is used. If\nthe sign has two display faces, and\nthe interior ang
Freestanding Ground Monument 5
Source-backed freestanding/ground/monument sign rules: then the sign\narea is one sign face only; however,\nif the two faces are of different sizes\nor shapes, then the larger is used. If\nthe sign has two display faces, and\nthe interior angle between the two\nfaces is greater than thirty (30)\ndegrees, then the sign area is the\nsum of the areas of the two faces.\ne.\nMulti-faced signs. If a sign has three\nor more faces, then the sign area is\nequal to fifty (50) perc
Source-backed nonconforming signs: 04. General provisions for signs.\nThe following general sign provisions shall\napply to this article and to all lawful conforming\nand nonconforming signs, unless otherwise\nindicated.\n(1)\nMeasurement of Sign Size (Sign Area).\nThe area of a sign is measured or\ncalculated as follows:\na.\nBackground panel signs. Sign copy\nthat is mounted, affixed, or painted\non a background panel or area\ndistinctively painted,
Permits
Permit Required 11
Source-backed sign permit requirement: property rights. \n(1) \nLegal nonconforming signs: \na. \nA legal nonconforming sign is a sign \nthat lawfully existed at the time of \nthe enactment of this article that \ndoes not conform to the regulations \nas specified in this article. \nb. \nAll legal nonconforming signs exist-\ning on August 1, 2016, may continue \nto be utilized only in the manner \nand to the extent that it existed at \nthe time of the adop
Advertisement
Advertisement
Prohibited
Prohibited Signs
Source-backed prohibited signs: be\nerected, operated or placed on any property. Any\nlawfully existing permanent sign structure or\nsign type that is among the prohibited signs and\nsign types listed below shall be deemed a\nnonconforming sign subject to the provisions of\nSection 8.00.10, Nonconforming Signs.\n(1)\nDiscontinued signs.\n(2)\nAnimated signs.\n(3)\nAttached signs that are taller than the\nwall of the building to which the sign is\na
Prohibited Signs 3
Source-backed prohibited signs: may be allowed up to two (2)\ntemporary signs per business, on that\nbusiness premises. Such signs may be\nfeather signs no more than twelve (12)\nfeet in height; sandwich boards of six (6)\nsquare feet per side or less: or cardboard\nor plastic freestanding ground signs no\nlarger than 18 5 × 24\n5 which are attached\nto the ground by wire supports no larger\nthan 1/8 5 wide or less. Such signs may be\non the busine
Source-backed temporary sign rules: al or other nonplanar sign\nis fifty (50) percent of the sum of the\nareas, using only the four vertical\nsides of the smallest four-sided\npolyhedron which will completely\nenclose the entire sign structure.\n(2)\nMeasurement of Sign Height. The height\nof a freestanding sign shall be measured\nas the vertical distance from the average\nfinished grade of the ground below the\nsign excluding any filling, berming,\nmo
Temporary Signs 2
Source-backed temporary sign rules: distance from the average\nfinished grade of the ground below the\nsign excluding any filling, berming,\nmounding or excavating solely for the\n§ 8.00.04\nAPPENDIX A—LAND DEVELOPMENT REGULATIONS\n2437\nSupp. No. 4", "asurement of Sign Height. The height\nof a freestanding sign shall be measured\nas the vertical distance from the average\nfinished grade of the ground below the\nsign excluding any filling, berming,\nmo
Allowed in all land use districts; government signs do not require a permit, but the permit requirement for other temporary signs is not specified in the provided facts.
Temp Sign Rules
Commercial column (CO/I): max 8 temporary signs per parcel, max 16 sq ft each, max 8 ft high; duration and permit requirements are not specified in the provided facts.
Window Signs
Window Sign Allowable Area
No more than 25% of the window surface.
Need the full sign-code report?
The full interactive report includes all sign types, illumination rules, permit requirements, and source citations — for free.